Delivers precise dimming control of 0-10 volt fluorescent and LED fixtures. Designed to control of electronic low voltage AC lighting ballasts or transformers Reverse Phase Dimmer Each unit can be a dimmer, and ON/OFF switch or a. radiant® 0-10V LED/Fluorescent Dimmer, Tri-Color. Note: Fixtures may stop dimming lower once 1VDC is reached, per ANSI C82.11-Annex A for 0-10V controls. Offers control of practically any dimmable bulb, from any smart device, from anywhere. Lighting will fade on when the sensor detects occupancy and off after the space has been vacated. Both the sensor and the Controller may be powered from a single power pack. Dimmer switches let you adjust the brightness level of the lighting in any room, and create the ambiance you desire at any given moment. For code-compliant automatic-off lighting control, an occupancy sensor input may be wired to the controller. When the Controller signal output drops to 0, the auxiliary relay (WattStopper power pack) will turn the controlled fixtures off after one to two seconds. ![]() This switch features an LED indicator that signals whether the. The ELCU-200 or some like device needs to be involved in the overall emergency management system to monitor the loss of normal power so that the 0-10 volt emergency lighting will not only be ON but ON at 100%.Ġ-10V dimming is smooth across the fixture’s dimming range (consult driver manufacturer for lowest output level). Invest in long-term energy savings by installing this WattStopper low voltage dimmer switch. If the Emergency lighting was in a dimmed state when the normal power was lost, the emergency lighting will be at 100% versus last dimmed level. The DCLV2 opens the 0-10V circuit at time of power loss. The 0-10V dimming switches are not designed to dim the load directly, but through a power. If you're dimming one bulb, this probably isn't a problem. The total wattage of all lamps is less than or equal to the maximum wattage rating on the dimmer switch. Use standard dimmers on 120 line voltage and low voltage dimmers for 12V and 24V applications. The DCLV2 can be used with the ELCU-200 to turn the lights to full ON upon an emergency. BEST ANSWER: The 0-10V dimming switch can handle a maximum of 25mA. The dimmer switch is rated for the same voltage as the lighting application. If connected to a sensor, the lights will fade on to the preset level and fade off, based on occupancy. If switched to Auto-On mode, the DCLV2 defaults to 50% Partial-On if no adjustments are made. The DCLV2 is programmed to default to the Manual-On setting. Users may also enable the sensor to trigger occupancy, the DCLV2 will normally set the load to the dimming level that it was at when Manual-On or Auto On is enabled. Users operate the 0-10V Controller by pressing up or down on the paddle to raise or lower light level. Sinks up to 50mA, to control 25 drivers/ballasts wired in parallel and sourced at 2mA (more drivers/ballasts are possible with lower current fixtures)Ĭompatible with ELCU-200 Emergency Lighting Control Unit May be used for on/off lighting and 0-10V dimming control The device can be combined with the BZ-150 power pack and a CI or DT Series ceiling sensor to detect occupancy and turn lighting off after the space is vacated.ĭCLV2 is programmed to default to the Manual-On setting.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |